Bs010l (motion Sensor) For Led Strips With Light Photosensitive Sensor, 12v Motion Sensor, 12 Volt Motion Sensor

Products Description

BS010

Black Housing,Black Lens

BS010WL

White Housing, White Lens

Passive Infrared Sensor
PIR(Passive infrared) Motion sensor is photoelectric device can detect human movement by detecting Infrared ray emitted by human body. Operating voltage is 5~25VDC, and output voltage is equal to input voltage. High sensitivity, Easy to install.

Automatic Induction
When people enter into the sensing range, Motion sensor will output a voltage equal to input voltage, after the delay time, it will output 0V; During the delay time if motion detected, the delay time will reset, and start a new delay time.

Application
Widely used on the Motion-activated lighting, LED strips Security System, automatic sensory device and more.

Specifications

Details Images and Applications

Product Feature:
* [Motion Activated] : Sensor function triggered by motion, you can use this small motion sensor switch to control lighting like Led strip lighting.
* [Light Sensor Adjustable]: This function allows you to use the motion sensor in different ambient condition, for example, you set the light sensor value to 20 lux, when the room ambient light value is above 20 lux, the light won’t turn on, but when room ambient light value is less than 20 lux, the sensor can turn light on when motion detected within sensing range.
* [Delay Time Adjustable- Please set this to its minimum value first then try to figure out your values for the Sensitivity and
Light Sensor- this will save your time]: The delay time controls how long the light stays on once it gets triggered, during the delay time if motion detected, the delay time will reset and start a new delay time.
* [Sensitivity Adjustable]: The sensitivity controls how close you need to be to the sensor in order to activate it.
* [Wide Application]: You can use this sensor in different occasions like entryway lighting, cabinet lighting, gun safe lighting, pantry lighting, under the bed rails lighting.

Detect Angle and Connection:

Note
1. Don’t exposed to direct sun light or lighting, big wind, near a heater or air condition.
2. Don’t fix it at a place where there are obstructing material (eg. Glass, dense clothes) which IR cannot get though.
3. Don’t fix it in strong shock or vibration environment.
4.The first time use the PIR Motion detector module, it need about one minutes initialization time, during this time, the signal triggered by the module not stable, after one minute, module will be normal.
5. The sensitivity for left-right direction is better than up-down direction, so please make sure the installation direction is left-right.